Wrap ribbon around the neck of a bottle. Cut craft wire and bend to form holders for gift tag. Insert one end of each wire into the cork bottle stopper. Instructions for each tag, shown below:
Tag 1 (left in group):
Other Supplies: Cardstock, Patterned Paper, Ink, Ribbon, Ribbon Flower
Die-cut a tag of your choice out of patterned paper and ink edges. Die-cut a Baroque Ornament out of cardstock and attach to the tag. Trim away excess. Embellish with a ribbon bow and ribbon flower. Tie a length of twine through the hole. Place in wire holder until ready for use.
Tag 2 (center in group):
Other Supplies: Cardstock, Patterned Paper, appliqué flower Accent, Ink, Ribbon, Twine
Die-cut a tag of your choice out of patterned paper and ink edges. Die-cut a Baroque Ornament out of cardstock and attach to the tag. Die-cut a Fanciful Border out of cardstock and trim to fit along the bottom of the tag. Wrap a ribbon around the tag and tie in a bow. Embellish with an appliqué flower accent. Tie a length of twine through the hole. Place in wire holder until ready for use.
Tag 3 (right in group):
Other Supplies: Cardstock, Brayer, Craft Metal, Ink, Lace, Ribbon, Twine
Die-cut a tag of your choice out of cardstock. Use a brayer to apply ink to the female (negative) side of the Baroque embossing folder; carefully place a piece of cardstock inside the folder and emboss. Remove the embossed paper and set aside to dry. Clean the brayer, then apply ink in a contrasting color and roll over the tag to highlight the raised designs. Attach a small length of lace along the bottom of the tag. Wrap a ribbon around the tag and tie in a bow. Die-cut and emboss a Jeweled Tassel from thin craft metal and attach to the tag. Tie a length of twine through the hole. Place in wire holder until ready for use.
