Flip Side Table Runner

Project #18969
18969

Dress up for dinner! Add charm to any table with a quilted runner that’s custom made to match your décor.



Fabric Requirements:

Yardage Fabric Cutting Instructions
1 yd Light aqua print Cut (16) tall wedges
(with right side UP on die)
Cut (16) short wedges
(with right side UP on die)
1 yd Yellow print Cut (8) short wedges
(with right side UP on die)
Cut (8) tall wedges
(with right side UP on die)
3/4 yd Gray print Cut (24) tall triangles
3/4 yd White print Cut (48) small triangles
25" x 58" Backing fabric
1/3 yd Binding fabric Cut (4) 2 1/4" wide Strips x WOF
23" x 56" Batting

Notes:

  • Finished Size: 17" x 50"
  • All seam allowances are 1/4" unless noted.
  • WOF = width of fabric

Piecing the Blocks:

  1. For the triangle block unit, gather and arrange as shown the following: a light aqua tall wedge, a light aqua short wedge, a gray print tall triangle, and two white print small triangles (Diagram 1).
  2. Sew the light aqua short wedge to the right side of the gray tall triangle. These pieces are dog-eared to easily align at the bottom edge. Press the seam allowance toward the short wedge.
  3. Sew the light aqua tall wedge to the opposite side of the tall triangle/short wedge unit. Press the seam allowance toward the tall wedge.
  4. Sew the white print triangle to each side the light aqua tall wedges. Press the seam allowances toward the wedges.
  5. Repeat steps 1−4 to make 16 triangle units.
  6. To complete the block, lay out two triangle units as shown in Diagram 2. Sew together in pairs, pressing the seam allowances open.
  7. Repeat steps 1−4 using the yellow print in place of the light aqua and following Diagram 3. Make eight triangle units.
  8. To complete the block, lay out two triangle units. Sew together in pairs, pressing the seam allowances open.
  9. Arrange the blocks using the quilt photo as a guide. Sew the blocks in rows, then sew the rows together, matching the seams and placing a pin at each intersection to match the points.

Finishing:

  1. Layer the backing, batting and quilt top. Quilt by hand or machine as desired.
  2. Sew the binding Strips together to form one long Strip. Fold wrong sides together lengthwise, and press.
  3. With a 1/4" seam, sew the raw edges of the binding to the edges of the right side of the quilt. Turn the folded edge of the binding to the back side of the quilt and stitch in place by hand, mitering the corners.

  • Diagram 1

  • Diagram 2

  • Diagram 3

We use cookies to personalize content, analyze site traffic and to serve push notifications and targeted ads. By continuing to use this site, you consent to our use of cookies. Click here to learn how we use cookies for a better browsing experience.
OK